![](graphics/jmspacer.gif) |
|
Circa:
1930's-40's
Price: $95.00 USD
Description: This is a nice clean steel back 14" long blade backsaw or miter saw. It is fairly sharp and straight. Ready to use, cuts very nicely, but could use some light sharpening. No broken or missing teeth..
|
![](graphics/jmspacer.gif) |
|
Circa:
late 1800's
Price: $42.00 USD
Description: This is a nice quality made larger sized spoke shave, 10" wide x 2" cutter width. The cutter nearly flat with about 1/32" convex sweep per side noted when a straight edge is held up to the cutter, in ..
|
![](graphics/jmspacer.gif) |
|
Circa:
1930's-40's
Price: $70.00 USD
Description: This is a nice clean crisp brass 24" long folding rule marked "THE LUFKIN RULE CO. MADE IN U.S.A.", and also marked "INCHES IN 8THS CIRC. INCHES IN 8THS". The overall condition is very good with a g..
|
![](graphics/jmspacer.gif) |
|
Circa:
1940's
Price: $65.00 USD
Description: This is a nice clean 1940's Rabbet Plane marked "STANLEY NO. 192 MADE IN U.S.A." on the casting. It has a 1" wide cutter with no name on it. This cutter is sharp and in new condition. This plane is in..
|
![](graphics/jmspacer.gif) |
|
Circa:
1940's
Price: $72.00 USD
Description: This is a nice clean 1940's Rabbet Plane marked "STANLEY NO. 192" on the casting. It has a 1" wide cutter with no name on it. This cutter is sharp and in new condition. This plane is in good++ conditi..
|
![](graphics/jmspacer.gif) |
|
Circa:
1900-30's
Price: $95.00 USD
Description: This is a very good used 15" long transitional plane marked "FULTON TOOL CO. WARRENTED" on the cutter. Overall the plane is in very good condition with about 90% of it's original black Japanning intac..
|
![](graphics/jmspacer.gif) |
|
Circa:
1940's
Price: $40.00 USD
Description: Offering this 1940's era scew back cross cut saw with the medallion nickel plated with the balance scale well defined. Marked on the Medallion, "DISSTON * U.S.A. *". The steel blade is fairly straight..
|
![](graphics/jmspacer.gif) |
|
Circa:
early 1900's
Price: $42.00 USD
Description: This is a hard to find 1-1/4" boring machine auger bit (1.25 dia. x 12" long) (end shaft diameter is .50". Not marked by a maker's name. Overall good condition, not rusty, some staining, sha..
|
![](graphics/jmspacer.gif) |
|
Circa:
Unknown
Price: $40.00 USD
Description: This is a hard to find 2-9/16" boring machine auger bit (2.562 dia. x 16.5" long) (end shaft diameter is .498"), with a hex end that measures .45" across the flats. Not marked by a maker's ..
|
![](graphics/jmspacer.gif) |
|
Circa:
early 1900's
Price: $60.00 USD
Description: This is a nice clean combination wrench for either nut or pipe work. It has a very clear maker's mark and logo. The mark on the one side reads "BEMIS & CALL H & T CO. SPRINGFIELD MASS.". It measures 1..
|