![](graphics/jmspacer.gif) |
|
Circa:
mid-1900's
Price: $25.00 USD
Description: This is a clean, new old stock, set of drill points for the North Brothers or Stanley Yankee smallest screwdrivers with the 7/32" diameter shanks. The is one plastic tube with metal cap, 3 sizes ..
|
![](graphics/jmspacer.gif) |
|
Circa:
1930's
Price: $60.00 USD
Description: This is a very good antique set of bit stock drill in a round wooden screw cap type case. It is rare to find a set like this in such nice condition! The case is marked "BIT STOCK DRILLS CLEVELAND TWIS..
|
![](graphics/jmspacer.gif) |
|
Circa:
mid-1900's
Price: $12.00 USD
Description: Offering this clean, used 6' zig zag rule marked "NO. 646 LUFKIN RUGGED RED END MODULAR". It features the hardwood sections, and brass hardware. It has the inch graduations on one side and the insid..
|
![](graphics/jmspacer.gif) |
|
Circa:
1930's-40's
Price: $50.00 USD
Description: This is a very nice, clean, and working measuring tape with the steel 50' tape, marked "THE LUFKIN RULE CO. SAGINAW MICH. U.S.A. 50" on one side, and "CHALLENGE STEEL TAPE U.S.A." on the oth..
|
![](graphics/jmspacer.gif) |
|
Circa:
early 1900's-Mid 1900's
Price: $30.00 USD
Description: This is an nice double wire cutters pliers 4" long overall. They are marked as follows: "SARGENT & CO. NEW HAVEN CONN. MADE IN U.S.A." (around the pivot pin area), and "SARGENT&quo..
|
![](graphics/jmspacer.gif) |
|
Circa:
early 1900's-Mid 1900's
Price: $20.00 USD
Description: This is a nice clean 6.5" long slip-joint pliers with the narrow or thin jaws, measure only .16" thick. It is marked "UTICA CUTLERY CO. UTICA N.Y. U.S.A." on both sides, near the pivot joint. A nice m..
|
![](graphics/jmspacer.gif) |
|
Circa:
1930's-50's
Price: $18.00 USD
Description: This is a nice quality 8" long electrians pliers marked "PEXTO 500-8" around the pivot point. Pexto is the trade name used on many tools made by Peck, Stow, and Wilcox. In very good w..
|
![](graphics/jmspacer.gif) |
|
Circa:
1920's
Price: $45.00 USD
Description: This is a nice clean 12" try square marked "STANLEY SW MADE IN U.S.A." with the sweetheart shaped logo on one side of the blade. The model has the steel blade, rosewood and brass beam, with the brass..
|
![](graphics/jmspacer.gif) |
|
Circa:
1863-1941
Price: $55.00 USD
Description: This is a nice clean double marking gauge that is not marked by Stanley, but is know to be a Stanley No. 71 as it matches their description in the old Stanley catalog. It has little wear overall, good..
|
![](graphics/jmspacer.gif) |
|
Circa:
1951-57
Price: $24.00 USD
Description: This is a nice clean marking gauge marked "DEFIANCE BY STANLEY MADE IN U.S.A. NO. 1291" on the main shaft. It has very little wear overall, a good steel scribe point. It has inch graduation from 0-6" ..
|