Stud Removal Nuts for Stanley Cast Iron Planes For Sale

Stud Removal Nuts for Stanley and Record Cast Iron Planes. Also Keen Kutter, Winchester, Millers Falls, Craftsmen, Dunlop, Wards Master, Wards Lakeside, Rev-O-Noc and later Union Planes.
If you have a 9/32"-24 left hand thread, these nuts will allow removing the Plane Iron Depth Position Stud from the frog without damage to the stud or the adjustment wheel. See #8A on the attached Stanley Plane Parts Diagram to locate the Plane Iron Depth Position Stud. These Stud Removal Nuts are machined a few thousandths larger to allow easy threading, even on the old rusty ones.
Dave Corinth Video Removal Instructions:1) Remove the adjustment nut (wheel) from the stud by turning in a clockwise direction. If the adjustment wheel is difficult to turn, use soft jaw pliers or Cannon plug pliers to avoid damage.2) After removing the adjustment wheel, add a few drops of penetrating oil where the stud threads into the frog and let it soak in for a few minutes.3) Thread on both Stud Removal Nuts past the rounded end of the stud and tighten against each other with two 7/16 inch open end wrenches.4) Now turn the rear Stud Removal Nut, the one closest to the frog, in a clockwise direction with the open end wrench and remove the stud.
We will combine shipping on multiple items and refund the savings. Receive a $3.00 refund on this item when you order more than one item for shipping at the same time.
MW-TCA members will receive a 10% discount rebate. Just send us a message and let us know you are an MW-TCA member. We will send your 10% discount refund promptly through . Thank you for your support of Mid West Tool Collectors Association.
User Comments:
"These are fantastic! If you restore planes and need to remove the adjustment stud then you need these! Other methods may or may not work. But every stuck stud I have came out with these."
-William Janke (janke50) Georgetown, TX