When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
We are experiencing a high volume of orders and have to push the production time a bit further. Thanks for all of your patience!
Hold Fasts for woodworking. Built for standard 3/4" hole. These are hand forged out of 5/8" solid round bar Ideal for 1-1/2" or thicker bench top. If you have specific requirements we can customize some aspects of these. Woodworkers in Santa Fe, NM buy them from me and love them. Approximately 5" reach and 12? from top of arc to end of shaft.
One recommendation I had was to texture the shaft. I leave them unpolished, but I do not texture. Feel free to modify them as you wish. Some people do rough them with sand paper.
These are of forged steel (they will not break like the chinese cast iron) and at a significantly lower cost than even those of well known high quality tool makers such as Lie Nielson.
Thank you so much for all the response! Any questions or suggestions are welcome and appreciated!
