New Set of 12(x) 1mm TPU 3D-Printed Silencer Washers for 24mm/30mm Sanwa Buttons For Sale

Hello.

I am selling sets of 12(x) 1mm thickness TPU silencer washers for 24mm and 30mm Sanwa arcade buttons. Each quantity is a set of 12 washers, enough for a standard lever-less controller with 4 directional buttons and 8 action buttons. These washers help dampen the noise that Sanwa 24mm and 30mm microswitches produce when pressed. To install these, you will need to remove the plunger on the Sanwa buttons and place the TPU washer inside. To ensure you do not damage/scratch your existing buttons, you will need to place electric tape or something similar around the tip of a screwdriver or knife-edge and carefully lift the button plunger. I advise that you remove the plungers with the buttons removed and outside of your enclosure. These washers can be installed on either side.

These washers come in 3 configurations:
12(x) 24mm Washers (24mm All Button Lever-Less Layout)
12(x) 30mm Washers (30mm All Button Lever-Less Layout)
11(x) 24mm Washes and 1(x) 30mm Washer (Standard Hitbox Layout with 30mm Up button)

These items are 3D-printed to order and are only currently available in black. Please be aware that there will be some slight imperfections in the prints, but the functionality of the washers will not be affected.

Please allow 1 business day for order processing as these are printed to order.

These items will ship free via USPS Ground Advantage.

Contact me with any questions or if you need a combination of 24mm and 30mm washers. Thanks for looking.